MINI FlexPod Gauge Mount

THANK YOU for purchasing the MINI FlexPod Gauge Mount from CravenSpeed. This product is made from the highest grade materials, and is guaranteed to be free from defects.

Parts Included:

  • 1 Mounting Bracket
  • 3ea Bracket Screws
  • 2ea Gauge Pods
  • 2ea Socket Head Cap Screws
  • 2ea Press-in Cap Screw Plugs

Tools Required:

  • T20 Torx Driver
  • Philips Head Screwdriver
  • Allen Key Driver

 Use this bracket to mount gauges and see exactly what is going on in the engine of your 3rd generation MINI. This kit is designed to allow the driver to position gauges on the steering column without the need to drill into your precious 3rd generation MINI Cooper.


It is important to note that this CravenSpeed Pro Series Mount is compatible only with F56 MINI Cooper vehicles

Procedure

arrow-tip

    1. There are two screws hiding underneath little caps, holding the factory instrument cluster in place.  First remove the caps and then the screws--one on each side. Use T20 Torx Driver.

    step1.jpg

    IMG_9884.JPG

    2. Slide the tach towards you, and remove the electrical plug from the rear of the factory instrument cluster to free it completely.

    step2a.jpg

    step2b.jpg

    step2c.jpg

    There is a small tab on the connector that, unless depressed, will keep it connected to the factory instrument cluster.  This connector can be stubborn, so be patient so as not to break the connector.

    On cars with heads-up-display (HUD), there will be an additional wire that can not be disconnected, in which case, installation will have to be done more carefully not to put too much stress on the wires. 

    3. Remove the 3 factory screws from the bottom of the factory instrument cluster.  Note that some are deep.  Use a philips head driver.

    4. Now grab the main bracket from your CravenSpeed FlexPod Gauge Mounting Kit and place it on the factory instrument cluster.  Using the provided screws, tighten it down. (Note: These screws are slightly thicker than the OEM screws, and all three are the same length) Once the bracket is secure (no wiggle) do not continue to tighten, as this will just strip out the plastic housing.

    5. Re-connect the electrical clip, slide your tach back into place, and put the screws on both sides back into place using the same T20 as before.

    6. Next, attach the pods to both mounting points using the included socket head cap screws and a an allen key driver.

    7. Put the press-in cap screw plugs over the socket head cap screws for a nice, clean look.

    7. Voila!  You did it!