Gemini Phone Mount for Gen 2 MINI Install Guide

THANK YOU for purchasing the MINI Gen2 Gemini Smartphone Mount from CravenSpeed. This product is made from the highest grade materials, and is guaranteed to be free from defects.

Parts Included:

  • Gemini Phone Mount for Gen 2 MINI
  • Magnetic Base
  • 2 ea Phillips Head Screws

Tools Required:

This kit is designed to allow the driver to position a smartphone for heads-up view without needing to handle the device. The Gemini mount allows you to customize your view by adjusting the extension arm to the angle that suits you.


The installation time for this product is approximately 15-30 min.  It is highly recommended that you only use magnetic tip drivers, as the screws securing the tachometer to the steering column are easy to drop behind the dash and can be tricky to recover.


It is important to note that this CravenSpeed Pro Series Mount is compatible only with Gen2 R55, R56, R57, R58, R59, R60 and R61 MINI Cooper vehicles

Procedure

arrow-tip

    Step 1 - Removing the Tachometer

    Start by lowering the steering column to the lowest position.

    Find the 2 screws that fasten the tachometer to the steering column and remove them using your T-30 Torx Driver.  Be careful not to drop them as this can double your install time! (This is where a magnetic tip comes in handy)  Keep these Torx screws safe as you will need to re-install them later.

    The tachometer is fastened to hidden rails under the steering column, so take note as you remove it.  It will be important to re-align the tach onto this rail for proper re-installation.

    Step 2 - Install the Bracket onto the Tachometer

    Use a Phillips head screwdriver to remove two of the three screws in the back of the tachometer. (shown below) You will not need these to complete the installation, but it is a good idea to hang onto them in case you ever remove the Gemini Mount.

    Align the mount with it’s aluminum spacers over the two holes shown here:

    Use the included screws to secure the bracket to the back of the tach. These screws are slightly longer and wider than the factory screws. This is to ensure a secure attachment of the mount to the tach. They require a bit more torque to install than the stock screws. Once the screw bottoms out, do not keep tightening as you risk stripping out the hole.

    Step 3 - Re-Install the Tachometer

    Align the tachometer back onto the steering column and re-install the two T-30 Torx screws.

    Step 4 - Choose a Device Holder and Adjust As Needed

    Select which device holder you would like use (XXL Clip or Magnet). Next, simply loosen the collar and pop the holder onto the ball at the end of the extension arm, then tighten the collar back up. You can switch holders at any time using this same procedure in reverse. The extension arm can be adjusted to your preference as well with a 5/32" Hex Driver and 7/16" Wrench. Simply loosen the nut and bolt that secure the extension arm, adjust it into your preferred position and re-tighten the nut and bolt.

!